FOG BLASTER PRO™ BELT

FOG BLASTER PRO™ is used as a hand tool, and as a pole-based tool for the 'hunt-and-destroy' of pathogens. When we are raising the FOG BLASTER PRO on a pole, we are raising 4-5lbs as a fully loaded single unit, and 9-10lbs as DOUBLE BLAST.

Ergonomics and Efficiency are very important for commercial service providers, and at all times, we have a responsibility to use the safest techniques possible.  

FOG BLASTER PRO™ BELT is a POLE MOUNT

When using FOG BLASTER PRO™ with FOG BLASTER PRO™ POLE, we want to load your body with the weight of the kit, not your arms - and so we added the holster function to the kit. Simply attach the belt around your waist, position the mounting point center front, raise the FOG BLASTER PRO™ POLE, and place the base of the pole in the mounting point.  Ideally, use two arms on the pole until you have some experience, then you can alternate arms, which is also very ergonomic (alternating left brain, right brain). 

FOG BLASTER PRO™ BELT as CABLE CONTROL

 In order to deliver the maximum efficiency of the operator, we use 110V and 220V (EU, AUS/NZ) mains power  - there is just a limit to what a 16 WATT battery can do!  As a result, we are the same as a janitor with a backpack vacuum, or a pressure washer with a hose - we are connected to the source of power (or pressure) and cable management becomes part of The FOG BLASTER PRO™ technique. 

As we are using extension cables (not supplied), there is a junction of the female plug on the extension lead, and the male plug from FOG BLASTER PRO™. This junction needs to be protected so it doesn't pull apart if the cable gets caught on something, or if you walk past the full extended length of the cable.  To manage this, POLE BLASTER BELT has two caribeeners for cable control. Simply thread the cable through each caribeener (either from the left or right) and connect to FOG BLASTER PRO™ plug  - this will stop the extension lead from pulling on the FOG BLASTER cable, especially when it is up on an extended FOG BLASTER PRO™ POLE. 

FOG BLASTER PRO™ BELT as a LIQUID FOG™ BACKUP

In order to keep FOG BLASTER PRO™ lightweight during the application service, we limit the LIQUID FOG™ bottle size to 16 floz.  This means the application time is between 9 and 22 minutes per 16 floz bottle, yet the operator may have a much larger job, and does not want to be going back and refilling the LIQUID FOG™ bottle to continue working.  To overcome this, FOG BLASTER PRO™ Kit has 4 x 16 floz bottles in the case, and FOG BLASTER PRO™ BELT has two BOTTLE HOLDER mounts (with MEGA-CLIPS) so you can, at your discretion, carry up to one hour of operation time) at maximum flow rate) on your belt, with the weight carried on the operator's body, thereby ensuring maximum ergonomics.  

FOG BLASTER PRO™ BELT (included in FOG BLASTER PRO™ Kit) includes:

1 x BELT 

1 x POLE MOUNT (fitted)

2 x CARIBEENER (fitted)

2 x MEGA-CLIP (fitted)

To learn more about BOTTLE HOLDERS, click here.